Delta StrikeHelp Centre

How to: Replace Genesis hanger board

This guide will walk you through on how to replace the genesis hanger board. PCB – PC2063

  1. Start by powering off the charge rack
    1. This can be done by unplugging your power brick located in your power supply box on the wall
    2. Unplug all cords going to the hanger board
  2. Unscrew the 4 screws holding in your hanger board. 
  3. Gently pull the board down at an angle get the transmitter over the magnet. 
  4. Remove the hanger board and re-install the new one following the steps in reverse

PCB – PC2063